Hi Rika
Oil pump modification is already done on the new engine. I did it while it was on the bench. I have a long thin jaw puller which worked perfectly getting the rotor off the shaft.
Long rods and 101mm pistons for the long rods.
Standard size head gasket.
I,m looking forward to installing them.
Will have a look at the exhaust valves when I remove the heads and cylinders. If light coloured or damaged , then I will replace. The plugs I removed had a good colour.
Rexer remap and some dyno time.
Hopefully have a nice engine
Gus
Oil pump modification is already done on the new engine. I did it while it was on the bench. I have a long thin jaw puller which worked perfectly getting the rotor off the shaft.
Long rods and 101mm pistons for the long rods.
Standard size head gasket.
I,m looking forward to installing them.
Will have a look at the exhaust valves when I remove the heads and cylinders. If light coloured or damaged , then I will replace. The plugs I removed had a good colour.
Rexer remap and some dyno time.
Hopefully have a nice engine
Gus
-------------------------------------------------------
